FLAMELUX Alps Installation Guide download pdf (Page 4)

IMPORTANT INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

1. Do not connect this heater to a programmer, timer, separate remote control system or any other device that switches the heater on

automatically, since a fire risk exists if the heater is covered or positioned incorrectly.

2. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to

avoid a hazard.

3. In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external

switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

4. Do not use this heater in the immediate surroundings of a bath, shower or swimming pool.

5. If the glass becomes damaged, do not use the heater in order to avoid a hazard.

6. Always make sure the electrical socket is accessible and located adjacent to but not above the heater.

7. This heater must be mounted to the wall.

1. This heater must be fitted onto a flat wall. Ideally, install the heater directly to a brick wall, masonry surface or the internal wooden

frame of a plasterboard wall. If the wooden frame behind the plasterboard is not accessible use a minimum of four heavy-duty anchors

that are suitable for the weight of the heater.

2. We do not recommend that the heater be fitted to a wall covered in blown vinyl wallpaper, polystyrene tiles, etc.

3. It is important that the heater be never installed under a shelf or flammable materials such as curtains.

4. If the heater is to be mounted on to a plasterboard wall with wooden studs, make sure the wall is strong and stable enough to hold the

weight of the appliance. The vapor control barrier must not be damaged, and the structural members of the house must not be damaged.

We recommend minimum 12mm thick plasterboard.

5. Before drilling into walls, always check that there are no hidden wires, pipes, etc. Make sure that screws and wall plugs supplied are

suitable for supporting the unit in your surface. Consult a qualified person if you are not sure.

Handling and unpacking

Before starting the installation of this fireplace, please read the following:

1. The installation should be carried out by two adults to avoid injury or d amage. If for any reason it is considered too heavy, please

obtain assistance.

2. When lifting the fireplace, always keep your back straight. Bend your legs and not your back. Avoid twisting at the waist. It is better

to reposition your feet.

3. Avoid upper body / top heavy bending. Always bend from the knees rather than the waist. Do not lean forward or sideways while

handling the heater.

4. Always grip the heater with the palm of the hand. Do not use the tips of fingers for support.

5. Always keep the heater as close to the body as possible. This will min imize the cantilever action.

6. Use gloves to provide additional grip.

7. Unpack the package and lift the product gently out of the box, put it on a flat surface with the front panel facing up.

E-3

Safety Warnings

Installation tips

1 2 3 4 5 6 7 8 9 ... 49 50

No comments

FLAMELUX Alps Installation Guide Page 4